MK2B Aluminum Heat Bed 12v or 24v

MK2B Aluminum Heat Bed 12v or 24v

Be the first to review this product

Availability: In stock

$28.00
  • OR

    Quick Overview

    All features from MK2A and you also can operate this board now with 12v or 24v
    - a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity
    - The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief. 


    Copper plated holes as shown in reprap wiki: http://reprap.org/wiki/PCB_Heatbed


    Tech specs heat bed MK2A



    • Dimensions 214mmx 214mm

    • Laminate FR4 1.6+-0.15mm

    • 2 layer, 35µm copper

    • Red Soldermask - both sides

    • White Silkscreen - both sides

    • Power Input: 12v or 24v

    • copper plated holes

    • resistance between 1.0-1.2 ohm (12V) - 3-3.4 ohm(24V)


     


    Tech specs for the EPCOS thermistor included in this set (this is the most popular thermistor used in reprap)


    Content of package:


    - 1 x MK2B Dual Power PCB
    - 1 x 100K ohm thermistor, un-soldered (all packed one by one in each one small bag)

    MK2B Aluminum Heat Bed 12v or 24v

    Double click on above image to view full picture

    Zoom Out
    Zoom In

    More Views

    Details

    All features from MK2A and you also can operate this board now with 12v or 24v
    - a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity
    - The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief. 


    Copper plated holes as shown in reprap wiki: http://reprap.org/wiki/PCB_Heatbed


    Tech specs heat bed MK2A

    • Dimensions 214mmx 214mm
    • Laminate FR4 1.6+-0.15mm
    • 2 layer, 35µm copper
    • Red Soldermask - both sides
    • White Silkscreen - both sides
    • Power Input: 12v or 24v
    • copper plated holes
    • resistance between 1.0-1.2 ohm (12V) - 3-3.4 ohm(24V)

     

    Tech specs for the EPCOS thermistor included in this set (this is the most popular thermistor used in reprap)

    Content of package:

    - 1 x MK2B Dual Power PCB
    - 1 x 100K ohm thermistor, un-soldered (all packed one by one in each one small bag)

    Product Tags

    Use spaces to separate tags. Use single quotes (') for phrases.