The Pegasus 10" kit is the latest addition to our set of full 3D printer kits. The Pegasus printer uses OpenBuilds V-SLot Linear Rail which provides Smoother Operation at Higher Print Speeds and the frame is built from the same OpenBuilds V-Slot Extrusion for a rigid frame. The Pegasus also comes with a Direct Drive Extruder and an E3D hot end.
Standard 12 business day lead time (you order will leave our warehouse 12 business days after you have placed your order)
This kit contains everything you need to build the 10" Pegasus except for a 12v 30 amp power supply, Insulation, usb cable, glass and a print surface like hairspray. See page 4 of the build guide for specific links.
The average builder can complete the Maker Farm 10" Pegasus 3+ hours from start to printing, Compare that to 5 hours for the Printrbot and 8 hours for the Deluxe V2 Prusa.
10"x10"x10" Build Envelope*
RAMPS 1.4 Electronics
50 micron layer height
Heat bed & Heat Bed Relay
GT2 Pulley's and Belts
.40mm E3D-v6, E3D-Lite6 E3D Hot end for 1.75mm filament or E3D-v6 hot end for 3mm filament
Pegasus Direct Drive Extruder (Optional Dual Extruder*) or Titan Extruder (works with 3mm or 1.75mm filament)
66oz-in Motors for all axis' (Pre-Wired)
Bed leveling kit
V-Slot Extrusion (Higher print speeds and smoother operation)
Every kit will now come with a Built in Spool Holder!
Assembled dimensions 22"Wx20"Dx24"H (with spool of filament installed)
Micro Adjustable Z Endstop
Aluminum Heat Bed Mount
Optional LCD Interface
Slot Cover for Wire Management
You will need basic hand tools, soldering iron, Piece of Glass, Insulation, Hairspray and Power supply (see links below) to complete your build
Power Supply - Mean Well NES-350-12 12V 350 Watt Ul Switching Power Supply 110-240 Volt
Insulation - 12 Inch x 12 Inch Cork Tile for Heat Bed Insulation
Hair Spray - Extreme Hold and Control Anti-Humidity Hairspray 5 8.25 Ounce (6 Pack)
Pegasus Build Guide
*Build area can vary depending on binder clip placement
^Dual Extruders double the complexity of the Extruder/hot end setup, they also double the potential problems you can have. For the easiest and most simple printer get a single extruder setup.
Extrusion may be Black, Silver or a mixture of both.