LCD's

3 Item(s)

per page

Grid  List 

Set Descending Direction
  1. Full Graphic LCD Controller with Smart Adapter

    Full Graphic LCD Controller with Smart Adapter

    Regular Price: $69.00

    Special Price $60.00

    The Smart LCD Controller lets you print without a PC.

    Kit Includes 1 Smart Adapter (Fully Assembled)

    1 A graphical smart controller with a 128x64 Dots LCD and a SD Card reader

    30-35cm long flat cables, with the smart adaptor.

    1 set of Headers to connect to your RAMPS 1.4 Board (May require Soldering)

    Firmware, hardware and settings required: Firmware: You need Marlin firmware v3 or newer. If you are using older firmware, you must re-flash your board. The latest Marlin firmware is available here: github.com/ErikZalm/Marlin Hardware required: - Ramps 1.4 - Mega2560 board - SD Card Configuration: After re-flash you must edit the config.h according to my post in reprap wiki. reprap.org/wiki/RepRapDiscount_Smart_Controller

    Or you can download the preconfigured firmware here: RAMPS Graphical LCD Firmware

    Learn More
  2. LCD/SD Reader for RADDS Electronics

    LCD/SD Reader for RADDS Electronics

    $37.00

    LCD/SD-Display with Reset- and Back-Buttom for RADDS v1.1 Learn More
  3. LCD Cables

    LCD Cables

    $2.00

    1 set of LCD Cables used on i3v and Pegasus printers These cables may or may not work for your LCD (60cm Cables Pictured) Learn More

3 Item(s)

per page

Grid  List 

Set Descending Direction